Publicité
Les langues disponibles
Les langues disponibles
finishing
EN
5.3
glass door installation and removal
Care must be taken when removing and installing door to ensure that the gasket at the top of the door does not
bunch. When removing the glass door, a simple procedure must be followed in order to not damage the compo-
nents.
A. Lift the cast top off the appliance.
B. Remove securing bolts on cast front (located behind
either side on the top) using a 10mm wrench (not
supplied).
D. Open valve control door.
34
W415-4084 / A / 06.01.22
1
2
C. Tilt top of cast front forward and lift out.
E. Pull quick release handles (located on bottom of either
side) forward and release 'T' latches. 'T' latch is threaded
and can be loosened or tightened to adjust for an effective
door seal.
Publicité
