Clatronic EM 3062 Mode D'emploi & Garantie page 44

WARNING:
• Attention, the cutting blades are extremely sharp! Handle with extreme
care when using the appliance and when cleaning the blades!
• Warning! The blades are very sharp. Before inserting or removing the
blades, always remove the mains plug.
• Do not leave the knife unattended when it is ready to operate.
• Never immerse the basic device in water.
• Always remove the mains plug before cleaning the device.
• Do not cut any frozen food or bones with the electric knife.
• Do not operate the knife for more than 5 minutes without a break.
• Remove the motor device and the accessories from the box. Also remove
any pa
GB
• Wipe all the parts with a moist cloth to remove all the dust that may have
deposited on and in the device during transport. Then mount the device
again by proceeding in the opposite order.
WARNING:
Please be particularly careful when handling the knives. There is a
danger of injury. Only hold the blades as near to the ends as possible or
by the plastic handling surfaces.
• Assemble the blades as shown in illustration 1 (ABB 1).
• Insert the ends of the knives into the retainer on the motor device.
• Press the blades in the direction of the motor device until the ends are felt
to lock in place. Check that they are fi rmly attached.
• Insert the plug in a duly installed 230 V/50 Hz socket.
34
Switching on
05-EM 3062 44
Special Safety Instructions
Putting the device into operation
ckaging materials that may be present.
13.10.2006, 8:44:59 Uhr