Panasonic SC-PMX802M Mode D'emploi page 6

Network settings
You can stream online music services or music files from
your smartphone/tablet to this system. To use these
features, this system must join the same
internet-connected network as the compatible device.
This system can be connected to a router using a LAN
cable or built-in Wi-Fi ® . For a stable connection to the
network, a wired LAN connection is recommended.
Note:
• If you try to change the network settings immediately after
turning on this system, it may take some time until the
network setup screen is displayed.
• If "NEW FIRMWARE FOUND/PRESS [OK]" is displayed
after the network connection is set up, the firmware for this
system is available.
– Refer to "Firmware updates" (
update.
– For the update information, refer to the following
website.
https://panasonic.jp/support/global/cs/audio/
Preparation
If you install the "Google Home" app on your
smartphone/tablet, you can set up a connection using
the application.
• When using the Chromecast-enabled apps to play music
on this system, set up a connection using the "Google
Home" app.
• Make sure that the Wi-Fi function is activated on your
smartphones/tablet.
1
Install the "Google Home" app on your
smartphone/tablet.
To download the "Google Home" app, visit:
https://www.google.com/cast/setup/
2
Connect your smartphone/tablet to the same
network as this system before setting.
6
• Make sure that the network is connected to the
internet.
6
Wired LAN connection
e.g.,
Broadband router, etc.
1
Disconnect the AC mains lead.
2
Connect this unit to a broadband router, etc.
using a LAN cable.
3
Connect the AC mains lead to this unit and turn
this system on.
• When the connection is established, the network LED
(blue) is lighted on the main unit.
4
Press [RADIO, EXT-IN] repeatedly to select
13) for details on
"NETWORK".
5
Start the "Google Home" app and follow the
on-screen instructions to set up a connection.
( 7)
Note:
• While the AC mains lead is disconnected, the LAN cable
must be connected or disconnected.
• Use category 7 or above straight LAN cables (STP) when
connecting to peripheral devices.
• Inserting any cable other than a LAN cable in the LAN port
can damage this unit.
• When a LAN cable is connected, the Wi-Fi function may be
disabled.
LAN cable
(not supplied)
Wireless LAN connection
Preparation
1 Disconnect the AC mains lead.
2 Disconnect the LAN cable.
3 Place this unit as close to the wireless router as
possible.
4 Connect the AC mains lead to this unit. (
Note:
• The setting will be cancelled after the set time limit. In that
case, try the setting again.
• When the connection is established, the network LED
(blue) is lighted.
Network setting for the first time
1
Press [Í] to turn this unit on.
• "NET SETUP" is displayed.
2
Press [2, 1] to select "YES" and then press
[OK].
• "SETTING" is blinked.
3
Start the "Google Home" app and follow the
on-screen instructions. ( 7)
Note:
• This unit will be displayed as "Panasonic PMX802-****" if
the device name is not set. ("****" stands for characters
unique to each set.)
([PMX802M] Displayed as "Panasonic PMX802M-****".)
• You can check your network information (SSID, MAC
address and IP address) from the "Google Home" app.
• Some items on the "Google Home" app are irrelevant to
this unit.
• When this unit is switched to standby mode and turned on
before the network setting is complete, "NET SETUP" is
displayed. Set "NO" to turn off the display.
4)