Muting The Beep Tone; Turning On The Clock Display; Power Select Function; Maintenance - Sony CDX-2100 Mode D'emploi

Muting the Beep Tone

Press the button while pressing
6
the SEL button.
To reactivate the beep tone, press these buttons
once more.
Note
When connecting an optional power amplifier to the LINE
OUT, the beep tone is disabled.
Turning on the Clock
Display

— Power Select Function

Only for cars with accessory position on the
ignition key switch
To turn the Power Select Function on
Press the button while pressing
OFF
the SEL button.
To turn the accessory position ON or OFF, the
clock will be displayed or not.
To avoid battery wear, the clock is not
displayed when the unit is initialization.

Maintenance

Fuse Replacement
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse
blows again after replacement, there may be an
internal malfunction. In such a case, consult
your nearest Sony dealer.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as
this could damage the unit.
Actual total number:

Dismounting the Unit

1
While pushing in on the left side of the
front cover, insert the tip of a thin
screwdriver as shown in the illustration,
then pry off the front cover.
Thin screwdriver
(Be careful to not break the front cover.)
2
Repeat step 1 on the right side. Then the
front cover will be removed.
3
Use a thin screwdriver to push in the clip
on the left side of the unit, then pull out
the left side of the unit until the catch
clears the mounting.
4
Repeat step 3 on the right side.
Fuse (15 A)
5
Slide the unit out of the mounting.
E
Sony CDX-2100 ( ,F) 3-810-607-11(1)
EN
9