Publicité
Les langues disponibles
Les langues disponibles
Cleaning and maintenance
Disconnect the appliance from the
socket and let the coffeemaker cool
down. Never immerse the appliance
in water. Use a damp cloth with
washing-up liquid and rub dry after-
wards.
Do not use abrasive or scouring
agents.
The glass jug can be cleaned under
running water or in a dishwasher.
Descaling
Like other hot water appliances the
coffee maker has to be descaled
periodically. A considerable longer
brewing time and a higher noise level
are an indication that the appliance
needs to be descaled.
The following indications are guide-
lines which refer to a daily use in the
household.
Hardness
Hardness Descaling
degree
intervals
1 water with
0-7° dH twice
low descale
a year
calcium content
2 water with
>7-14° DH four times
medium descale
a year
calcium content
3 water with
>14-21° dH every 6
high descale
weeks
calcium content
4 water with
>21° dH monthly
very high descale
calcium content
6
1° dH corresponds to aprox. 0.18 mmol/l
Ca and MG Ions
You can ask for the degree of hard-
ness in your residential area at the
responsible waterworks or the local
administration.
Use a conventional decalcification
agent according to the instructions by
the manufacturer.
Fill the fresh water tank to the maxi-
mum number of cups with decalcifi-
cation solution. We recommend the
®
use of durgol
express. This is higly
efficient and yet gentle. Fill 2
®
durgol
express into the fresh water
tank and dilute with the same amount
of tap water.
Insert the permanent filter and place
the carafe into the machine. After
always a minute during the filtration,
switch off the appliance for a few
minutes; the decalcifying agent will
be most effective by this method.
Repeat the process each time with
fresh decalcifying agent until the dis-
turbing noise is eliminated. Never fill
hot decalcifying solution into the
appliance.
Caution! Filter a maximum fresh
water fill-up through after decalcifying.
Warranty compensation does not
exist for damages that occur due to
non-compliance.
Attention: After descaling it is neces-
sary to operate the appliance with a
full container of water as done before
the first use.
Damages caused by the non-obser-
vance of these instructions are not
covered by the guarantee.
The appliance complies with
CE
the European directives
2006/95/EC and 89/336/EEC.
At the end of its lifetime this
product must not be dis-
posed of through the normal
domestic waste, but it should
be handed to an assembly
point for the recycling of electrical
and electronical appliances. You can
inquire about details at the local
administration.
Subject to technical changes.
For UK use only
1. This product is supplied with a 13 A
plug conforming to BS 1363 fitted to
the mains lead. If the plug is unsuita-
ble for your socket outlets or needs
to be replaced, please note the follo-
wing. If the plug is a non-rewireable
one, cut it from the mains lead and
immediately dispose of it. Never in-
sert it into a socket outlet as there is a
very great risk of an electric shock.
2. The replacement of the plug at the
mains lead has to be done according
to the following instructions:
Warning - This appliance must be
earthed.
Important: The wires in this mains
lead are coloured in accordance with
the following code:
green/yellow:
Earth
blue:
Neutral
brown:
Live
As the colours of the wires in the
mains lead of this appliance may not
correspond with the coloured mar-
kings identifying the terminals in your
plug, proceed as follows:
- the
wire which is coloured green
and yellow must be connected to
the terminal which is marked with
the letter E or by the earth sym-
bol
, or coloured green and yellow.
- the wire which is coloured blue
must be connected to the terminal
which is marked with the letter N
or coloured black,
- the wire which is coloured brown
must be connected to the terminal
which is marked with the letter L or
coloured red.
3. If a 13 A (BS 1363) plug is used it
must be fitted with a 13 A fuse con--
forming to BS 1362 and be ASTA
approved. If any other type of plug is
used, the appliance must be protec-
ted by a 10 A fuse either in the plug
or adapter or at the distribution board.
If in doubt - consult a qualified
electrician.
4. Never use the plug without closing
the fuse cover.
Publicité
