1. GENERAL INFORMATION
•
The distance between the remote controller and the indoor unit should be within 7m
and without any obstacle.
•
The presence of an electronic-starter fluorescent lamp or a wireless telephone in the
room can interfere with the reception of the signal by the receiver. It is advised to
reduce the distance between the signal transmission head and the receiver hole.
•
Full display or unclear display during operation indicates that the batteries need to
be changed.
•
If the remote controller does not operate normally, remove the batteries and reload
several minutes later.
Inlet grill
Air outlet
Horizontal deflector (To adjust
the up-down airflow)
Display board
1.
Signal receiver
2.
Room temperature display
At the reception of the signal, it displays set temperature. Otherwise, room temperature is
displayed. This temperature is given for information purpose only.
3.
Operation mode indicator (the indicator is ON when the compressor is operating)
4.
Wi-Fi
OPERATION MANUAL
Air inlet
1
2
Air purifying filter (inside)
Vertical deflector (To adjust the
left-right airflow)
4
3
Wi-Fi module port
(Option)
Emergency/Power on switch
Display board
35