Selve i-R Marki Send Plus Notice D'utilisation page 55

Explanation of functions/terms used
SUN M/SUN L
The sun protection function only starts from the upper end limit
and is only active in the sliding switch setting 'Auto'.
The threshold value for SUN M is pre-set to 08 and for SUN L
to 07. The value -- indicates that the sunshade function has been
deactivated. The brightness value can be set to values ranging
between 01 (very overcast) and 15 (direct sunlight).
The existing sunlight setting and the new setting to be made are
shown on the display. The field for the new sunlight setting flashes.
Sun threshold Brightness (approx.)
Value
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
If the sun threshold value is exceeded for longer than 3 minutes,
the awning moves downwards to the set intermediate position.
The lower end position is the intermediate position in the factory
setting.
If the sun threshold value is not achieved for longer than 15 min.,
the awning is retracted. A manual command (UP, STOP, DOWN)
in automatic mode deactivates the sun protection function until
the awning is moved to the upper end limit. An automatic time
command (e. g. i-R Timer Plus) deactivates the sun protection
function.
kLux
5
10
15
20
25
30
35
40
45
50
60
70
80
90
100
55
GB