Andis UltraEdge AGCB Instructions D'utilisation Et D'entretien page 5

10. To disconnect turn control to "Off" then remove plug
from outlet.
11. WARNING: During use, do not place or leave
appliance where it may be (1) damaged by an animal
or (2) exposed to the weather.
12. Oil blades frequently. Blades may become hot
during use.
13. Keep the appliance dry.
14. The appliance is intended for trimming purposes only.
SAVE THESE INSTRUCTIONS
REFER TO PAGE 2 FOR FIGURES.
OPERATING INSTRUCTIONS
Plug cord into electrical outlet, operate 100-240 volt, 50-60 cycle AC electrical current
or as noted on unit.
UNIVERSAL AC/DC POWER ADAPTER
The unit is equipped with a universal AC/DC power adapter (Figure A. Interchangeable
input plugs are included for use in most countries around the world (Included plugs
may vary by model). See Figures B-F.
INSERTING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. Insert tabs on top of plug into slots on power adapter (Figure G).
3. Push lower half of plug towards power adapter until it snaps into place.
REMOVING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. Push up on tab on bottom of plug until plug releases from adapter.
2-SPEED OPERATION
Your Andis clipper is equipped with two cutting speeds. The speeds are adjusted
using the slide switch actuator on the top of the unit (Figure H). Setting "O" indicates
the off position, Setting "1" is low speed and Setting "2" is high speed. After using
your Andis clipper, rewrap cord and store in a safe place.
5