jbc ADVANCED AR 5800 Mode D'emploi page 10

ADVANCED HANDPIECES RANGE
All the Advanced soldering handpieces range can
be connected to the AR 5800 station.
The station AR 5800 includes the following products:
- 2245 handpiece ref. 2245000 with the 2245-003
cartridge Ref. 2245003. Power: 50W. For general
soldering work.
- AD 8245 soldering iron stand ref. 0788245.
- 2245-007 cartridge Ref. 2245007. It can be chosen
from a wide range of different 2245 cartridges to
adapt perfectly to the needs of the job (pag. 62).
The following soldering handpieces can be
connected to the AR 5800 station:
- Handpiece 2210 ref. 2210000. Power: 20W. For
high precision work, SMD etc. Available
cartridges 2210: see page 63.
The 2210 handpiece has to be connected to the AD
8210 stand which has been especially designed
for this handpiece.
AD 8210
soldering iron stand
Ref.0788210
2210 handpiece Ref. 2210000
2210 cartridges
9
One version of soldering iron handpiece covered
with heat isolater is available:
- 2245 Confort handpiece ref. 2245110.
These articles are not delivered with the station.
The 2210 and 2245 handpieces and cartridges
comply with the MIL-SPEC-2000 referring to the
potential difference between the soldering tip and
ground connection, must be less than 2 mV.
For a soldering handpiece to work properly, the
following components are required: a control unit, a
handpiece and the corresponding stand and
cartridge.
The 2245 soldering iron is connected to the station
in the following way:
The cable connection of the 2245 soldering iron is
connected to the plug in the AD 8245 soldering iron
stand and the cable connection of the soldering
iron stand can be connected to any of the two
connectors at the back of the station. Please find
the connection plan on figure.
Connector
2245 handpiece Ref. 2245000
ENGLISH
AD 8245
soldering iron stand
Ref.0788245
2245 cartridges