Haier JG45B Mode D'emploi page 12

How to change the door opening

This appliance has reversible doors but is delivered with a right hinged door. The left hand hinge kit comes with the
unit (in the box), should you wish to reverse the hinge on your unit.
1.Lower Hinge(Right)
4.Screws
7.Plastic Caps
10.Top Hinge(Left)
12.Door Limit Device
1.Open the door to a 90 degrees angle, take out the 2 screws (2) from lower door axis (3), remove the door
(6), Remove the axis plate (3) from the door. (Fig. A)
2.Unscrew the screw (14) located underneath the door frame and the limit device (13), and relocate it at right
top of the door frame. (Fig. A/B)
3.Remove two screws securing (4) the actuator (5) and remove it from the door. Install the actuator at the top
of the door frame.(Fig. A)
4.Remove plastic caps(7) from the door.(Fig.B)
5.Take out the 3 hinge screws (9) from the top hinge (right) (8) and remove it. (Fig. C)
6.Remove decorative nail from left top of cabinet and install spare top hinge (Left) (10) at left top of cabinet
with 3 screws. (Fig. D)
7.Following the above procedure, install the spare lower hinge to the left (12). (Fig. E)
8.When reinstalling the door, it will need to be flipped 180° from its original position to ensure that the handle
is on the correct side and that the actuator is on the bottom. Install the door by sliding it onto the top hinge
pin, then replace the door axis by placing the hinge pin in the bottom of the door and securing it to the bottom
left hinge with two screws.(Fig. E)
9. Insert the plastic caps(7) to cover the holes.
3.Door Axis
2.Screws
6.Door
5.Actuator
9.Hinge Screws
8.Top Hinge
12.Lower Hinge(Left)
11.Hole Cover
13.Screw
10
EN