Publicité
Les langues disponibles
Les langues disponibles
TO CONVERT APPLIANCE FOR USE WITH
NATURAL GAS
WARNING
Electrical power and gas must be turned off prior to
conversion.
If this appliance has been converted for use with LP gas, each of the
following modifications must be performed to convert the unit back to
natural gas.
A. Replace all orifice spuds
Perform Steps 1 through 4 on page 5.
For Step 5: Locate the colored brass natural gas orifice spuds that were
originally installed in this appliance before its conversion for use with LP
gas. Observe the color of each of the spuds and note the correct burner
location for each spud as shown in figures 14 and 15.
Complete Steps 6 through 9 on page 5 to complete the installation of
natural gas main spuds in their correct locations.
Save the orifices removed from the appliance for future use. They will
be needed if this appliance is again converted for use with LP gas.
B. Invert cap in appliance pressure regulator.
(See figures 10 and 11.)
With the appliance installed the appliance regulator should be located
as shown in either figure 3 or figure 4 (page 3). Identify the type of
appliance regulator and follow the instructions in the appropriate
illustration.
C. Adjust low flame as instructed on page 6 item C.
After Steps A, B and C have been completed, check the appearance of
each burner's flame at the Hi and Lo settings against figure 13. If the
flames appear too large or too small, make sure all steps were
completed correctly.
All manuals and user guides at all-guides.com
INSTALLATION OF NATURAL GAS
ORIFICE SPUDS
9
4 BURNER MODEL (30² WIDE)
FIGURE 14
5 BURNER MODEL (36² WIDE)
FIGURE 15
Publicité
