The On/Off Trigger Switch - Evolution FURY 1-B Notice Originale

www.evolutionpowertools.com
Adjustment of the Cutting Angle
• Loosen the Bevel Locking Screw found at the front
of the saw (Fig. 6).
• Tilt the blade to the required angle (Fig. 7).
• Tighten the Bevel Locking Screw securely.
Note: An angle scale (0
– 45
0
into the Bevel Locking Quadrant to aid setting.
(<10.2) OPERATING ADVICE
Carry out routine safety checks each time you use the machine.
Check that all safety guards are operating correctly, and that all
adjustment handles/screws are tightened securely.
Check that the blade is secure and installed correctly. Also check
that it is the correct blade for the material being cut.
Check the integrity of the power cord.
Always clamp the workpiece to a rigid support such as a bench
or saw horse whenever possible. (10.2>)
(5.4)

THE ON/OFF TRIGGER SWITCH

This machine is equipped with a safety start trigger switch. (Fig. 8)
To start the tool:
• Push in the safety lock button on the side of the
handle with your thumb.
• Depress the main trigger switch to start the motor.
WARNING: Never start the saw with the cutting edge of the
saw blade in contact with the workpiece surface.
) is incorporated
0
17
Fig. 6
0-45 o
Fig. 7
Fig. 8
EN
DE
FR
IT
NL