Accessories - Hausmann 6849.468 Manuel De L'utilisateur

Bdal 6849.468 07.12.2009

ACCESSORIES

Using mitre guide
See Figure 28
The mitre guide can serve as extra support for routing small workpieces
and for ends of long workpieces.
NOTE: Make sure that the fence and mitre bar slot are parallel
before cutting.
To cut mitre angles, unclamp knob that secures the protractor head.
Turn head up to 60° in either direction. Retighten knob.
When making cuts using the mitre guide, hold the workpiece firmly
against the fence, the mitre guide, and the table.
Do not allow any body part to be in line with the router
bit at any time when the mitre gauge is in use.
Doing so could lead to serious personal injury.
Using featherboards
See Figure 29
The featherboards provide support for the workpiece by holding it securely,
which helps minimize chatter and kickback.
Insert the 2 featherboards as shown below, with the sliding blocks
positioned in the slot of the fence and then securely tighten the knobs.
Insert the third featherboard in the slot of mitre channel and tighten knob.
62
12:29 Uhr Seite 62
Fig. 28
Fig. 29