Hausmann 6849.468 Manuel De L'utilisateur page 58

Bdal 6849.468 07.12.2009
OPERATION
Using your router/router table
Before you start work with your new router table:
Refer to your router owner's manual to see how
the height of the cut can be adjusted.
Make sure router is unplugged before starting
depth/height adjustments.
NOTE: Using scrap board that is smooth and true is recommended
for making this adjustment.
See Figure 21
1. At the end of the board, use a soft pencil to mark line #1.
This indicates the depth of the cut.
2. Then mark line #2, indicating the height of the cut.
3. Place your board so that it is snug against the fence face.
The end with lines #1 and #2 should be near the bit.
4. Loosen fence clamping knobs enough so you can move the fence easily.
Move fence and board so that the board contacts the outer edge
of the router bit at line #1.
5. Tighten fence clamping knobs.
6. Adjust router height so the cutting edge of the bit contacts line #2.
7. Make sure bit is securely tightened in the collet.
Pencil line #1
58
12:29 Uhr Seite 58
Pencil line #2
Fig. 21