Hausmann 6849.468 Manuel De L'utilisateur page 57

Bdal 6849.468 07.12.2009 12:29 Uhr Seite 57
OPERATION
Insert Use
1. Select correct insert for the router bit and your application.
2. To assemble to router table, press the insert into the hole in the table,
applying pressure to all sides equally. This assures that insert snaps
into place.
3. Remove an insert by placing your finger into the hole in the center.
With light pressure, pull up on the insert.
NOTE: Remove the router bit from the router before attempting to remove
an insert.
Using fence
See Figure 20
To position the fence on tabletop, make this adjustment.
1. Place the fence on the tabletop.
2. Loosen the 2 knobs (W).
3. Slide the fence into the required position.
NOTE: Fence should always be parallel with the frontside of the table.
4. Tighten the knobs (W) by turning clockwise.
Adjustable
Fence
W
fence
Make sure that the 4 knobs (connected to the
2 adjustable fences) are securely tightened.
Adjustable
fence
W
Fig. 20
57