Hausmann 6849.468 Manuel De L'utilisateur page 46

Bdal 6849.468 07.12.2009
ASSEMBLY
See Figure 9
3. Place the fence on the tabletop so that the 2 flat nuts (X) are placed into
the 2 slots in the table. Slide the fence forward (always parallel with
the front of the table). When the fence is in the desired location tighten
the knob screws (W) by turning clockwise.
W
TO ATTACH THE FEATHERBOARDS
See Figure 10
1. Insert the hex head bolt (AE) into the sliding block (N). Place the sliding
block into the slot of the long featherboard (L). Secure by placing washer
(Y) over the hex head bolt (AE). Screw together by turning the knob (V)
clockwise.
NOTE: Do not completely tighten at this stage. Repeat the above for the
remaining 2 short featherboards (M).
AE (3)
V
Y
L
N
AE
46
12:29 Uhr Seite 46
W
Y (3)
Fig. 9
Fig. 10