Altrex RS TOWER 53 Mode D'emploi page 20

6. Assembly
• Check that all parts, necessary tools and safety aids are present (e.g. helmet, gloves, safety shoes).
• Required tools:
- Rope
- Spirit level
• Assemble the components following the steps shown in appendix T4 and T5
• Make all the connections as shown in Annex T3
• See the table below for the reference to the annex with the configuration table and configurations per type of rolling tower
EN
Configuration
RS TOWER 53-S
A
1. Start with a 7-rung frame (part B) and a walkthrough frame.
2. Put the wheels (part D) into the frames, put the brakes on and put them in an outward direction [T2 fig. F1 - F3].
3. Mount horizontal braces (part G) under the 1st rung on the upright [T2: fig. F4 - F5].
4. Mount the Safe-Quick
5. Mount the step stirrup.(part M)
6. Mount a temporary platform (part E) onto the 1st rung [F20 – F22].
7. Adjust the base section using a spirit level.
8. Mount the triangle stabilisers (part H) [T2 fig. F9 - F13].
B
9. Stand on the platform, place the 4-rung frames (part A) and lock them [F6 – F8].
10. At the outside, place the Safe-Quick
instruction label facing the inside [F14 – F18].
11. Hang a Safe-Quick
instruction label facing the inside [F14 – F18].
12. Mount two guardrail braces stepladder (part J) from the bottom upwards [F23 – F25].
13. Mount a platform with trapdoor (part E [F19 – F22].
14. Place the rolling-tower ladder (part K).
15. Enter the platform via the trapdoor.
16. Mount a temporary brace (part G) behind the centre Safe-Quick
C
17. Place the 7-rung frames (part B) and lock them [T2: fig. F6 - F8].
18. At the outside, place the Safe-Quick
instruction label facing the inside [F14 – F18].
19. Remove the Safe-Quick
the last frame mounted, with the instruction label facing the inside [F14 – F18].
20. Mount two guardrail braces stepladder (part J) from the bottom upwards [F23 – F25]
21. Mount a platform with trapdoor (part E [F19 – F22].
22. Place the rolling-tower ladder (part K).
23. Enter the platform via the trapdoor.
24. Remove the horizontal brace mentioned in Step 16 and mount it behind the centre Safe-Quick
Repeat Steps 17 through 24 until you achieve the required working height.
D
25. Remove the centre Safe-Quick
26. Mount the set of toe boards (part I).
27. Remove the horizontal brace (part G) mentioned in Step 24 and mount it under the top rung onto the upright.
28. Mount the void protection guardrail (part L).
20
www.altrex.com
Annex
T5
Guardrail(s) (part F) on the sixth rung with the instruction label facing the inside [T2 fig F14 - F18].
®
Guardrail (part F) on the top rung of the frame, which was the last frame mounted, with the
®
Guardrail (part F) from the centre of the top rung of the frame, which was the last frame mounted, with the
®
Guardrail (part F) on the top rung of the frame, which was the last frame mounted, with the
®
Guardrail (part F) mentioned in Step 11 and hang it from the centre of the top rung of the frame, which was
®
Guardrail.
®
Guardrail.
®
®
Guardrail.