Télécharger Imprimer la page

Kohler K-1913 Instructions D'installation page 48

Masquer les pouces Voir aussi pour K-1913:

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting (cont.)
Symptoms
18. Door will not stay in the
raised position.
19. Seal will not remain
inflated.
Troubleshooting the Heated Surface
1128532-2-G
All manuals and user guides at all-guides.com
Probable Causes
B. The bath is not leveled properly. B. Check the back ledge and the sides
C. The door gap is too big because
the pulley assembly is not
properly adjusted.
D. Water is splashing over the top
of the seal.
A. One or both counterweights are
not attached.
B. Door bumper needs adjustment.
C. The mounting bracket is not
adjusted properly.
D. There is excessive wear on latch
pin and/or strike plate.
E. The handle/latch mechanism
inside the door is not working.
A. There is a loose wire connection
under the door.
B. Error code on the controller is
activated.
C. Primary seal may be leaking.
D. Air line inside the door may be
pinched.
E. There is an air leak inside the
door.
F.
One or more of the solenoid
valves is leaking air.
48
Recommended Action
of the bath for level. Adjust the feet
until the bath is level if needed.
C. Adjust the pulley assembly inward.
D. Lower the water level when filling
the bath. Reduce sudden
movements when bathing.
A. Attach the counterweight(s).
B. Adjust the door bumper as needed.
C. Adjust the mounting brackets
inward using the slots.
D. Apply a small amount of oil to the
face of the strike plate, replace the
strike plate, or call the Customer
Care Center using the information
provided on the back page of this
manual.
E. Call the Customer Care Center
using the information provided on
the back page of this manual.
A. Check the 10-pin wire connection
located behind the plate on the
bottom of the door, opposite the
drain end.
B. Reset the controller.
lower the door
quickly tap the door switch 5
times
wait 3 seconds, then tap the
switch 11 times within a 5
second span
the controller should beep 3 to
5 times to indicate the issue
has been resolved, then go
quiet.
C. Call the Customer Care Center
using the information provided on
the back page of this manual.
D. Call the Customer Care Center
using the information provided on
the back page of this manual.
E. Call the Customer Care Center
using the information provided on
the back page of this manual.
F.
Call the Customer Care Center
using the information provided on
the back page of this manual.
Kohler Co.

Publicité

loading