Publicité
Les langues disponibles
Les langues disponibles
For Flat Back Screen
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into screen as shown
below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over tighten.
If screw cannot make three full turns into the screen, select a longer length screw from the baffled fastener pack.
Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
If you have any questions, please call Peerless customer care at 1-800-729-0307 or visit our website at
www.peerlessmounts.com/charts to locate your screen compatibility chart.
For Bump-out or Recessed Back Screen
Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
screen as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do
not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-729-0307 or visit our website at
www.peerlessmounts.com/charts to locate your screen compatibility chart.
All manuals and user guides at all-guides.com
SCREEN
SCREEN
SPACER
6 of 33
fig 2.3
MULTI-WASHER
SCREW
ADAPTER
BRACKET
(BB or CC)
fig 2.4
MULTI-WASHER
SCREW
ADAPTER
BRACKET
(BB or CC)
ISSUED: 09-20-06 SHEET #: 202-9167-3 01-26-07
Publicité
