Bosch 0601069100 Notice Originale page 19

English | 19
Practical Advice
Marking
You can mark the height of the laser beam using the centre mark (8) on the left and right
of the measuring tool when the beam runs through the centre of the reception field (10).
Ensure that the measuring tool is aligned perfectly vertically (when using a horizontal
laser beam) or horizontally (when using a vertical laser beam) when marking as the
marks will otherwise be offset from the laser beam.
Attaching using a magnet (see figure B)
If an attachment is not required to be especially secure, then the measuring tool can be
attached to steel parts using the magnets (5).
Maintenance and Service
Maintenance and Cleaning
Always keep the laser receiver clean.
Do not immerse the laser receiver in water or other liquids.
Wipe off any dirt using a damp, soft cloth. Do not use any detergents or solvents.
After-Sales Service and Application Service
Our after-sales service responds to your questions concerning maintenance and repair of
your product as well as spare parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you with any questions about
our products and their accessories.
In all correspondence and spare parts orders, please always include the 10‑digit article
number given on the nameplate of the product.
India
Bosch Service Center
69, Habibullah Road, (Next to PSBB School), T. Nagar
Chennai – 600077
Phone: (044) 64561816
Bosch Service Center
18, Community Center
Phase 1, Mayapuri
New Delhi – 110064
Phone: (011) 43166190
Bosch Power Tools 1 609 92A 7SG | (18.05.2022)