Ninja COFFEE BAR CF092 Serie Guide D'utilisation page 21

PROBLEMS
My cup, travel mug or
carafe overflowed.
Brew basket
overflowed.
Water left in my
reservoir.
Does it take coffee
pods?
My Ninja Coffee Bar is
leaking.
My Ninja Coffee Bar
beeped and did not
complete the full brew
that I selected.
Why is the second cup
that I brewed hotter
than the first cup?
*K-Cup is a registered trademark of Keurig Green Mountain, Inc. Use of the K-Cup trademark does not imply any affiliation with
or endorsement by Keurig Green Mountain, Inc.
POSSIBLE REASONS & SOLUTIONS
The cup, travel mug or carafe may not have been empty prior to brewing.
The water exceeded the Max Fill line on the water reservoir prior to brewing.
The Ninja Coffee Bar is designed to dispense the following amounts on Classic brew:
®
Cup 9.5 oz.
XL Cup 11.5 oz.
Travel Mug 14 oz.
XL Multi-Serve 18 oz.
Half Carafe 28 oz.
Carafe 43 oz.
Please ensure that you are using at least a 12 oz. cup for the cup size, 14 oz. cup for the
XL Cup size, 16 oz. travel mug for the travel mug size and 20 oz. travel mug for the XL
Multi-Serve size.
NOTE: On Rich Brew and Over Ice Brew there will be less volume dispensed. Specialty
Brew will deliver approximately 4 oz. and Cafe Forte will deliver approximately 8 oz.
Check the amount of coffee or type of grind used.
Ninja Coffee Bar allows you to fill the reservoir up to but not exceeding the Max Fill line
and Auto-iQ One-Touch Intelligence will only use the water needed for the brew size
™
and style selected.
After a brew you may notice leftover water in your water reservoir after filling to the
minimum fill line of the size selected. The water reservoir markings are minimum fill lines
that indicate if there is enough water for the proper brew size in the reservoir, but all
brew styles use different amounts of water to create the proper flavor and concentration.
You can brew multiple cups before needing to refill.
This brewer is designed to brew coffee grounds only. Do not insert pods or K-Cups
If the leak is coming from the brew basket, be sure all the parts are fit securely in the
brewer.
If the leak is coming from the bottom of the brewer, call customer service
at 1-877-646-5288.
Ensure the water reservoir is locked in place and is filled with enough water for the
desired brew.
Check the CLEAN indicator light. If illuminated, run a Clean Cycle with the appropriate
descaling solution or a white vinegar mixture. See Care & Maintenance section.
Check the Drip Stop indicator light. If illuminated, ensure the brew basket is fully inserted
into the brewer and open the Drip Stop once the vessel is placed under the brew basket.
If the problem persists, please call customer service at 1-877-646-5288.
Once the Ninja Coffee Bar has brewed the first cup, the brewing system is pre-warmed.
This enables any following brews to be slightly hotter. For a hot first cup, try pre-
warming your mug. Or after pugging in or turning on your brewer from Power Save mode,
allow 3 minutes for your brewer to preheat.
.
®
20
ninjacoffeebar.com