Publicité
Les langues disponibles
Les langues disponibles
V1.1
1.
Determine what DIN Shade number is
needed for the task.
2.
Press the MODE button until the Cut
icon (R) appears in the LCD. The DIN
Shade 5-9 icon (M) will also appear.
3.
Press the SHADE button until the icon
(Q) is flashing. Press the button to select the DIN shade.
GRINDING MODE
You can also use the welding mask to protect your face during grinding. This
will prevent the filter cartridge from darkening when bright sparks are
created.
1.
Press the GRIND button on the right
side of the goggles for 2 seconds to
activate grind mode.
2.
The grinding icon (S) will appear on the
LCD.
3.
An orange light inside the goggles will flash when in grind mode. You
cannot adjust the shade number.
4.
Press the GRIND button for 2 seconds to switch off GRIND mode.
BATTERY ICON
The battery icon (K) indicates the power charge available. Change the
batteries when down to a single bar that flashes (see Maintenance –
Battery Replacement).
WARNING! Failure to change a low battery may result in exposure
to UV/IR radiation and blinding arc light. A low battery may
compromise the delay timing and shade accuracy.
SLEEP MODE
The welding mask will enter sleep mode after 30 minutes of inactivity to
conserve the battery power. Push any button to activate the goggles.
The last shade setting in weld mode will be retained in memory. Cut and
Grind settings are not saved to memory.
LED LIGHT
1.
Push the power button on top to activate the light.
2.
Loosen a side knob slightly.
Visit www.princessauto.com for more information
TRUBLU LoPro Welding Mask Kit
8977084
Fig. 6
Fig. 7
9
Publicité
