PRO-POINT TRUBLU LOPRO Manuel D'instructions page 11

V1.1
EXTERNAL LENS
1. Grip the small tab on the bottom of the
outer lens (Fig. 10) and pull it out. The
lens will flex and slide out of the side
hooks.
2. Position the new lens into the left hook
by aligning the lens tab with the hook
opening (Fig. 11).
3. Bend the lens towards yourself and slip the
right side of the lens under the right hook,
aligning the tab and release the lens.
4. Gently push the lens into the goggles to
seat it in the opening.
REPLACE THE SILICONE PADDING.
The silicone padding is replaceable if it is torn or
damaged. The padding is held in place by tabs.
1. Pull the sides towards the middle to
disconnect the side tabs (Fig. 12).
2. Grip the padding by the upper left and right
corner and pull it from the goggle's body.
3. Position the new padding onto the goggle's
body. Gently press down on the left and
right side of the padding. Wiggle the
padding around until the side tabs lock into
place (Fig. 13).
4. Work your fingers around the inner edge of
the padding to force the tabs to lock into
place.
5. Gently pull along the padding edge to check
if it is secure. Repeat steps 3 and 4 if needed until the padding is
locked into place.
Visit www.princessauto.com for more information
TRUBLU LoPro Welding Mask Kit 8977084
Fig. 10
Fig. 11
Fig. 12
Fig. 13
11