PRO-POINT TRUBLU LOPRO Manuel D'instructions page 7

V1.1
BEFORE WELDING
1. Ensure that the internal and external protective films are removed from
the lenses.
2. Check that the batteries have sufficient power to operate the welding
mask.
3. Check that the arc sensors are clean and not blocked by dust or debris.
4. Check for head band tightness before each use.
WELDING MASK SETTINGS
The control panel is on the left side of the googles, with the exception of
the GRIND button, which is on the right side of the goggles.
1. Press the MODE button to cycle through the four modes: Weld (5-9),
Weld (9-13), Grind and Cut. The icons and numbers shown on the LCD
screen depends on which mode is selected.
2. Once a mode is selected, press the SHADE, SENS. or DELAY button
once to activate that setting. The icon will begin flashing.
3. Continue to press the button to cycle through the setting levels.
4. The icon will stop flashing after a few seconds, indicating the setting
is complete.
SHADE NUMBER SELECTION
1. Determine what DIN Shade number is
needed for the task (see Appendix A).
2. Select to the weld mode that has the
correct range, either Shade 9-5 (M) or
9-13 (N). The weld icon (L) will also be
visible (Fig. 4).
3. Press the SHADE button once to
activate the setting and then press it
again until the correct shade number
(Q) is displayed. It will only cycle
through the number in the selected
range.
Visit www.princessauto.com for more information
TRUBLU LoPro Welding Mask Kit 8977084
Fig. 4
Fig. 5
7