PRO-POINT TRUBLU LOPRO Manuel D'instructions page 12

8977084
BATTERY REPLACEMENT
1. Remove the small cover
screw on the inner right side
of the goggles (Fig. 13), then
slide the cover off the
battery holder.
2. Remove the old battery and
replace with a new CR2450
lithium battery. Check that the battery's polarity is correct.
3. Reinstall the cover.
REMOVING AND REINSTALLING THE
FACEPLATE
The faceplate is held in place by a lock and tab system on either side of the
goggles, just behind the control panel and grind button.
1. Press the left tab outward to free
it from the lock and hold it there.
2. At the same time, hold the onto
the faceplate and press against
the goggles on the same side. The
faceplate will pop off.
3. Repeat steps 1 and 2 on the other
side. Set the faceplate aside once
it is free.
4. Reattach the faceplate by aligning the locks and tabs on either side of
the goggles and faceplate.
5. Push the goggles down into place until the tabs catch onto the locks.
Check that the connection is firm on each side.
6. Clean the lenses of fingerprints after removing or installing the mask.
CLEANING
Clean the lens, welding mask shell and headband with a soft cotton cloth
and mild soap. Replace the headband when required.
12
TRUBLU LoPro Welding Mask Kit
For technical questions call 1-800-665-8685
V1.1
Fig. 14
Fig. 15