Publicité
Les langues disponibles
Les langues disponibles
8977084
3.
Adjust the light to the desired position.
4.
Tighten the side knob to secure.
5.
Turn the power off until ready for use.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged
or worn components. Only use identical replacement parts when
servicing.
3.
Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool.
An improperly repaired tool may present a hazard to the user
and/or others.
CHANGE EXTERNAL AND INTERNAL LENS
The external and internal lenses will wear out and need replacement after
a period of use due to exposure to the heat, fumes and particulate matter
generated during welding.
INTERNAL LENS
1.
Grip the inner lens at the top (Fig. 8) at
the molded indent and pull it out. The
lens will flex and slide out of the side
hooks.
2.
Position the new lens into the left hook
and push and bend the lens towards
you (Fig. 9).
3.
Slip the right side of the lens under the
right hook and release the lens.
4.
Gently push the lens into the goggles to
seat it in the opening.
10
TRUBLU LoPro Welding Mask Kit
For technical questions call 1-800-665-8685
V1.1
Fig. 8
Fig. 9
Publicité
