PRO-POINT TRUBLU LOPRO Manuel D'instructions page 13

V1.1
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a qualified
technician service the tool.
PROBLEM(S)
Irregular
Darkening.
Filter does not
darken or
flickers.
Poor vision.
Welding Cap
slips.
Visit www.princessauto.com for more information
TRUBLU LoPro Welding Mask Kit
POSSIBLE CAUSE(S)
Headgear is set unevenly so the
distance between the eyes and
the lens is different from the
left to the right side.
1. Front cover lens is dirty or
smoke covered.
2. Arc sensors may be dirty.
3. Welding current is too low.
4. Battery voltage is too low.
1. Check the clear covers
lenses and the electronic
filter lens for dirt or grime.
2. Protective film was not
removed.
3. Ambient light is not
sufficient to see.
4. Shade Number is not set
correctly.
The headband is not properly
adjusted.
SUGGESTED SOLUTION(S)
Adjust headgear so distance is
equal between the lens and
both eyes.
1. Clean or replace external
lens.
2. Remove external lens and
wipe the photo sensors
clean with soft lint free
cloth.
3. Adjust filter sensitivity to
the maximum.
4. Replace batteries.
1. Clean cover lenses and
electric filter lens.
2. Remove protective film.
3. Adjust the work area
lighting.
4. Reset Shade number.
Adjust the headgear tightness
adjusting knob for a tighter fit.
8977084
13