Razor A-Type Serie Manuel Utilisateur page 5

ChECk BEFORE RIDINg
q Collar Clamp
Using a 5mm allen wrench, check that the collar clamp bolt is tightened securely. This item is tightened and quality
inspected at the factory, but there is a slight chance that the effects of shipping or handling may have caused this bolt
to loosen.
q Baseboard/Steering Column Adjusting Screw
Using a 3mm allen wrench and with the scooter in the upright and locked position, adjust the set screw at the base-
board until there is no free-play between the baseboard and the steering column. Be careful not to over-tighten this
screw as it needs only be snug against the steering column. Verify the adjustment by releasing the steering column
from the locked position and folding the scooter. The locking lever should not bind and the folding movement should be
smooth. The spring-loaded mechanism should automatically lock and be fully seated in the upright position.
q Wheels and Bearings
Under normal circumstances and conditions, Razor wheels and wheel bearings are maintenance free. Nonetheless, it
is the responsibility of the owner or guardian to periodically inspect the wheels for wear and tear, the axle for proper
tightness and bearings for side-to-side play and loose parts. When a wheel or wheel bearing develops play, this is an
indication of excess wear and replacement is necessary. Replace immediately with only genuine Razor wheels. Worn
wheels/bearings are considered normal wear-and-tear and are not covered by the Razor Warranty. Wheels other than
genuine Razor wheels may not be compatible with your Razor scooter. The use of anything other than genuine Razor
replacement parts may affect your safety and will void your warranty.
q Cleaning your Scooter
Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or solvents as they may damage the
surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they may damage or dissolve the plastic
components or soften the decals or decal adhesive.
q how to Ride
Place one foot on the baseboard, push forward with the other foot. Steer. For enhanced cornering, lean slightly into the
direction of the turn. For controlled stops, apply the brake by stepping on the rear fender/brake. Razor recommends that
you practice applying the brake at various speeds and in an open area free from obstructions before riding your Razor
around others.
4
WARNINg: Failure to
properly secure the quick-release
lever may cause the T-tube to
telescope up or down while riding
which may cause you to lose
control and fall.
WARNINg: Keep
your fingers clear of the pivoting
mechanism when folding or
unfolding the scooter.
WARNINg: Wheelies
and other stunt-type riding reduces
your ability to maneuver and control
your scooter. Take the necessary
precautions, such as wearing
appropriate protective gear and
practice in a area safe for stunt
riding and free from obstructions.