Razor A-Type Serie Manuel Utilisateur page 4

SET UP AND USAgE INSTRUCTIONS (All SCOOTERS)
q Unfolding the scooter for first time use.
1
Insert and secure the left and
right handlebars by pressing the
spring-loaded buttons and
inserting them into the T-tube.
Note: The Joint lever is spring-
loaded and will automatically lock
in the upright position when fully
upright.
Note: The tension of the quick-
release lever can be adjusted by
tightening or loosening the allen
bolt. Be careful not to over-tighten.
You should always be able to open
and close the quick-release lever
by hand and the T-tube should slide
freely with the quick-release open.
2
Make certain BOTH handlebars
are properly locked onto the T-bar.
4
To adjust the height of the handlebars, open the quick-release lever and
slide the T-bar to the desired position and resecure the quick release lever to
lock into place. If the T-bar is raised to the maximum height, depress the push
button located directly below the quick release lever to lower the T-bar.
3
To release the folding
mechanism, put one foot on the
deck plate and push joint release
lever down. Raise handlebars up
until securely locked in the upright
position.
3
WARNINg: Failure to
properly engage the spring-loaded
buttons may cause the handlebars
to dislodge while riding and may
cause you to lose control and
fall. When correctly engaged the
handlebars will not rotate nor will
they move sideways. Note that
when properly engaged, the spring-
loaded buttons are clearly visible in
the holes on the T-tube.
WARNINg: Keep
your fingers clear of the pivoting
mechanism when folding or
unfolding the scooter. Make sure
others are standing clear.
WARNINg: Failure to
properly secure the quick-release
lever may cause the T-tube to
telescope up or down while riding
which may cause you to lose
control and fall.