Metabo HPT NT 1850DF Manuel D'instructions Et De Sécurité page 21

(4) Remove the fi nger from the trigger and press the
push lever against the workpiece.
□ THE NAILER MUST NOT OPERATE.
Do not pull the trigger
Depress
push lever
(5) Separate the push lever from the workpiece.
Next, point the nailer downward, pull the trigger and
then wait in that position for 5 seconds or longer.
□ THE NAILER MUST NOT OPERATE.
Pull the trigger
[Time out function]
When set in contact actuation mode, pull and
hold the trigger for at least 2 seconds to enter
time out mode.
Or when set in single sequential mode, press
and hold the push lever for at least 4 seconds
to enter time out mode. The LED will blink to
indicate time out mode.
The brad nailer is disabled in time out mode.
To return to normal mode, release the trigger or
lift the tool from the wood surface.
LED light
(6) Without touching the trigger, depress the push
lever against the workpiece.
Next, pull the trigger.
□ THE NAILER MUST OPERATE.
Hold the trigger back and depress the push
lever against the workpiece again.
□ THE NAILER MUST NOT OPERATE.
Separate the fi nger from the trigger.
Next, is operated again.
□ THE NAILER MUST OPERATE.
(7) Separate the push lever from the workpiece, pull the
trigger.
Depress the push lever against the workpiece within
2 seconds.
□ THE NAILER MUST NOT OPERATE.
(8) Set the nailing operation indicator blinking ON mode.
(CONTACT ACTUATION MECHANISM)
Push the nailing operation switch once, make sure
that the indicator is blinking Blue.
Blink in blue
Separate the push lever from the workpiece, pull the
trigger.
English
21