Garland Bolt 925 QGW Manuel D'instructions page 42

English
- Unscrew the plug again and check the mark left
by oil on the dipstick. The mark left by the oil must
be between the minimum and maximum marks.
- If the mark is below the minimum add a little more
oil and recheck.
- If the mark is above the maximum you will have
to remove oil from the crankcase. This tilt the
mower on side, so that the air filter is facing up,
and let out a little oil (put a container at the end
of the tube to prevent oil spilling from the machine
or floor).
8.2.2. FUEL FILTER
The fuel tank is equipped with a filter. This is
located under the fuel tank cap.
Periodically check the fuel filter. Do not allow dirt in
the fuel tank to avoid that the filter is dirty. A dirty filter
will cause difficult starting the engine and anomalies
in operation or stop it.
Check the fuel. If you see dirt, replace it.
If the inside of the fuel tank is dirty you can clean it
with petrol.
There is another fuel filter in the stopcock. For
cleaning follow the drawing.
8.2.3. CHECKING THE SPARK PLUG
The most common problems when it comes to
Maximum
starting a machine are produced by a dirty spark plug
or in poor condition. Clean the spark plug and check
it regularly. Check that the electrode gap is correct
(0.6 - 0.7 mm).
Mínimum
42/120