Garland Bolt 925 QGW Manuel D'instructions page 29

ventilation, remove everything that impedes the flow
of clean air to improve ventilation and do not return
to the area unless you have properly ventilated area
and be sure that ventilation is sufficient so that this
concentration of fumes does not happen again.
Do not refuel in locations where there is the presence
of open flames, sparks or heat sources. Always fill
the tank in well-ventilated areas and with the motor
stopped. Do not overflow fuel when filling the fuel
tank. In the event of a fuel leak be sure to remove
these leaks completely before starting, move the
machine away from the area of spillage and avoid any
source of ignition until all vapors are gone.
Add fuel before starting the machine. Never remove
the cap of the fuel tank while the engine is running or
when the machine is hot.
While you are refueling have the machine turned off
and make sure that the engine is cold. Never refuel
with the engine running or hot.
In the event of a fuel leak be sure to remove these
leaks completely before starting.
Do not refuel in closed rooms or poorly ventilated
areas or near flames.
Make sure the gas cap is properly closed while using
the machine.
Be sure to properly close the gas cap after refueling.
Make sure that the gas cap is properly closed while
you are using the machine.
Be sure to properly close the gas cap after refueling.
Always store fuel in approved containers that comply
with the European regulations.
Do not use fuel that it has been stored for more
than 2 months. A fuel stored for too long will cause
the starting of the machine to be more difficult and
an unsatisfactory engine performance. If the fuel
has been in the tank of the machine more than two
months, take it out of the machine and replace it with
one in perfect condition.
2.5. ELECTRICAL SAFETY
Do not expose this machine to rain or humid
conditions. If water enters the machine it
will increase the risk of electric shock.
The outlet of this machine must match the
base of the electric plug. Do not modify in
any way. Non-modified matching plugs will
reduce the risk of electric shock.
Do not leave this machine on the street overnight as
the moisture can damage the machine.
Do not touch the cords or plugs with wet hands.
Never use the machine with a damaged cord or plug.
Before connecting the machine check the plug and
cable for damage. If you discover any damage, send
your machine to a Service Center for repair.
Do not use this machine if the switch does not change
between "open" and "closed". Any machine that
cannot be controlled with the switch is dangerous and
must be repaired.
2.6. USE AND CARE OF THIS MACHINE
Use this machine, accessories, tooling, etc. in
accordance with these instructions and as intended,
taking into account the working conditions and the
work to develop. The use of this machine for other than
the intended use may cause a dangerous situation.
29/120
English