Garland Bolt 925 QGW Manuel D'instructions page 39

- If the connected device has higher consumption
that the generator can produce, the circuit breaker
will cut off electricity supply to protect the
generator.
- If this occurs unplug the electricity for at least one
minute, reconnect the circuit breaker.
7.2. VERIFICATION POINTS AFTER COMMISSIONING
Check that the noise of the machine is normal and
that it does not vibrate. If you detect any anomaly
in the machine stop immediately. In case of any
malfunction or problem take the machine in for
service to be repaired. In no circumstance should you
continue to use the machine if the operation does not
seem appropriate.
Check the voltmeter brand 220-230V. If the voltmeter
mark voltage is too high or too low to stop the
machine immediately.
Do not use the machine if it is damaged or improperly
adjusted.
7.3. TIPS FOR USE
- If you are connecting two or more devices to the
generator, connect them one by one starting with
the one using the most power.
- Remember that most of the devices require
more power than specified in the label to boot. It
could happen that this generator, although capable
of supporting the consumption of the appliance in
operation, cannot generate the energy needed for
its start-up.
- If you use this generator to give power to a
circuit of a house have the operation performed
by a qualified electrician. Inadequate connections
between the generator and the home appliances
could lead to severe damage to the generator and
to the connected devices or lead to fire.
- If you use the output of continuous current (DC) for
charging a battery installed in a vehicle 12V be
sure to disconnect the negative pole of the battery
terminal before connecting charging cables to the
generator.
8. MAINTENANCE AND SERVICE
Perform regular inspections on the machine in order
to ensure efficient operation of the machine.
For complete service, we recommend to take the
machine to your technical service provider.
Before performing any maintenance on the
machine or repair make sure that engine
has stopped and remove the spark plug
pipe. Perform all machine maintenance with
the machine placed on a flat, clear surface.
Never attempt adjustments on the machine if it is
running. Perform all machine maintenance while it is
placed on a flat, clear surface.
WARNING! Do not modify the machine. Any
inadequate use of these elements can cause SERIOUS
PERSONAL HARM OR DEATH.
Use only replacements suitable for this machine in
order to obtain a proper performance of the machine.
These replacements can be found in the official
distributors of the machine. The use of other spare
parts can cause accidental damage to the user and
people around machine.
39/120
English