Publicité
Les langues disponibles
Les langues disponibles
To do before you operate the product
•
Examine the work area and remove loose objects.
•
Do a check of the cutting unit. Refer to
check of the blades on page 6 .
•
Make sure that the gear housing is correctly
lubricated.
•
Make sure that the safety devices of the product
operates correctly. Do not use the product without all
safety devices installed correctly.
•
Make sure that all screws and nuts are tight.
•
Make sure that all covers are attached correctly and
not damaged before you start the product.
•
Make sure that the cutting unit stops when the
engine is at idle speed.
To do a check before start
1. Examine the work area. Remove any objects that
could be thrown out.
2. Examine the cutting attachment. Do not use blades
that are damaged.
3. Examine that the product is in perfect work order.
Examine that all nuts and screws are tight.
4. Make sure the gear housing is lubricated correctly.
To lubricate the bevel gear and gearbox on
See
page 10 for instructions.
5. Examine that the cutting attachment stops when the
throttle/power trigger is released.
6. Only use the product for the purpose it was intended
for.
7. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
To operate the product
1. Start near the ground and move the product up
along the hedge when you cut the sides.
2. Adjust the speed to align with the work load.
3. Make sure that the motor does not touch the hedge.
8
Operation
4. Hold the product near your body for a stable work
position.
5. Make sure that the end of the cutting equipment
To do a
does not touch the ground.
6. Be careful and work slowly until all the branches are
correctly cut.
To adjust the angle of the cutting unit
The cutting unit can be adjusted in 10 different positions.
1. Let the engine run at idle speed and make sure the
cutting unit does not move.
2. Pull down the position adjustment handle.
3. Tilt the cutting unit to the correct position. Use 1 of
the procedures that follow.
WARNING:
Do not operate the cutting
unit when you adjust the angle.
1472 - 003 - 01.07.2021
Publicité
