Publicité
Les langues disponibles
Les langues disponibles
•
Always wear heavy-duty gloves when you do
maintenance on the cutting attachment. The cutting
attachment is very sharp and can cause injury.
To assemble the hand guard and loop
handle (LRT-EX200)
1. Loosen the 2 screws and remove the coupling.
2. Assemble the hand guard and loop handle by
screwing them together. Take care to align the holes
in both parts.
3. Slide the loop handle and hand guard onto the shaft.
4. Slide the spacer into the slot in the loop handle.
5. Fit the nut and screw. Do not overtighten.
1472 - 003 - 01.07.2021
•
Keep the product in a locked area to prevent access
for children or persons that are not approved.
•
Use only original spare parts for repairs.
Assembly
6. Now make a final adjustment to give yourself a
comfortable working position. Tighten the screw.
7. Fit the coupling and tighten the 2 screws.
To install the harness support hook
(LRT-EX860)
1. Remove the screw to release the holder of the
harness support hook.
2. Put the harness support hook between the throttle
handle and the loop handle.
3. Install the screw to attach the harness support hook.
4. Adjust the length of the harness until the support
hook is level with your hip.
CAUTION:
The loop handle and
hand guard must not be fitted behind the
arrow marked on the shaft.
7
Publicité
