Publicité
Les langues disponibles
Les langues disponibles
ZEPHYRONLINE.COM
RF Remote Control
FCC Caution
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example -
use only shielded interface cables when connecting to computer or peripheral device. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Synchronization
To create a unique link between your liner and remote control please follow these steps.
1. With liner off, press and hold the "lights" button on the liner until the letter "F" shows on the display
screen.
2. Press the "lights" button on the remote, the lights on the liner will turn on and synchronization is
complete.
RF Remote Control Functions
Blower On/
1
2
Speed Selection
3
4
Lights Low/High/Off
5 Min Delay Off
Monsoon II Use, Care, and Installation Guide
Blower On/
Power Off
Blower On / Speed Selection
1
Press
Blower On / Power Off
2
By pressing
again and the entire hood will power off, including lights.
Delay Off
3
By pressing
appear in the lower right corner of the hood display
is on. The blower will change to speed 1 and shut down after 5 minutes.
Lights Low/High/Off
4
Switch lights to Low by pressing
Features & Controls
to power on blower and cycle through all six blower speeds.
, the blowers will power on at the last speed setting. Press
, the blower and lights will enter Delay Off mode. A dot will
once, again to High and again to switch Off.
indicating the function
19
Publicité
