Publicité
Les langues disponibles
Les langues disponibles
14
Reattaching the network adaptor to the console
Caution
• For safety reasons, do not connect the power plug
for the console to an electrical outlet until the
network adaptor has been reattached.
• When installing an authorized internal peripheral
in the console's expansion bay, refer to the
instructions supplied with the peripheral product.
1 ...
Place the network adaptor over the
expansion bay so that the mounting
screws line up with the holes in the
console. (The expansion bay is located on
the lower left side of the PlayStation
console rear.)
Network adaptor
2 ...
Fasten the network adaptor to the
PlayStation
2 console.
®
Turn the mounting screws in a clockwise
direction using a coin. Do not overtighten.
Notes
• Do not use a screwdriver to tighten the
mounting screws.
• Do not fasten the mounting screws too
tightly, as this may damage the screws
or console.
Mounting screw
2
®
Publicité
