Sony PlayStation 2 SCPH-39001/N Mode D'emploi page 13

Connecting the network adaptor with a network cable
You can connect the PlayStation 2 console to a
®
network through the NETWORK connector on
a network adaptor installed in the
PlayStation 2 console.
®
You can connect to a 100 mbps network using
100Base-TX cable or to a 10 mbps network
using 10Base-T cable. For details, refer to the
instructions supplied with the network device
you are connecting to (such as a router, DSL
modem or cable modem).
Warning
There is a protective sticker on the network connector
to help prevent accidental connection of the wrong
type of cable. Remove the sticker the first time you use
the network connector. After you have removed the
sticker, be careful not to connect cables of the wrong
type to the network connector.
Do not connect network cables or telephone cords of the
following types to the network connector; too much
electrical current may pass through the connector, causing
a malfunction, excessive heat or fire in the connector:
• Network cables of types other than 100Base-TX and
10Base-T
• Normal telephone lines
• An ISDN (digital) compatible public phone
• A PBX phone
• A home or business telephone network phone
• Other types of telephone lines
Note
When you connect to a network, the Internet service
provider may charge a usage fee. In some cases, the usage
charges may be more than anticipated. For details, refer to
the instructions provided with the software in use or
contact your Internet service provider.
Removing the network adaptor from the console
The network adaptor can be removed from the
console. It should only be removed for the
purpose of installing an authorized expansion
bay peripheral.
Caution
• For safety reasons, turn off the console using the
main power switch on the console rear, and
disconnect the power plug for the console from the
electrical outlet before removing the network
adaptor.
• The network adaptor serves as a protective cover
for the expansion bay and the expansion bus
connector, which is located within the expansion
bay. Do not leave the expansion bay uncovered for
an extended period of time. If your network
adaptor is lost or damaged, or for any questions or
problems concerning the network adaptor, contact
our technical support line at 1-800-345-7669.
• Do not connect any unauthorized internal
peripheral to the network adaptor, and do not
insert foreign objects into the expansion bay. Doing
so may damage the console, or cause a malfunction.
1 ...
Check that the 1 (standby) indicator on
the PlayStation 2 console front is lit up in
®
red, and turn off the PlayStation 2 console
®
using the MAIN POWER switch on the
console rear.
2 ...
Disconnect the power plug for the
PlayStation 2 console from the electrical
®
outlet.
3 ...
Disconnect the telephone cord and/or
network cable from the network adaptor.
Note
The network adaptor included in the PlayStation
online pack is intended only for use with the
PlayStation 2 console provided.
®
4 ...
Loosen the mounting screws.
Turn the mounting screws in a
counterclockwise direction using a coin.
Note
Do not use a screwdriver to loosen the mounting
screws.
Mounting screw
5 ...
Remove the network adaptor from the
console.
Remove the network adaptor by pulling it
away from the console.
2
®
Network adaptor
13
US
PlayStation 2
®
console rear