Broan-NuTone BKSJ1 Manuel D'installation, D'entretien Et D'utilisation page 15

Les langues disponibles

NOTE: The following procedure applies to both framed of frameless cabinet installations.

1 ] Run house power cable between service panel and hood location.

2 ] There are 2 pairs of recessed holes on each side of the top of the hood (on rear: A and B,

on front C and D on illustration below); these holes allow the range hood to hang on the

brackets (previously installed).

HORIZONTAL EXHAUST INSTALLATION ONLY

3 ] Temporarily hang the hood on the brackets using its 2 recessed REAR HOLES (A and B).

While holding the hood, run the house power cable into the hood through the strain relief

previously installed in step 6 on page 10.

4 ] Unhook the rear holes from the brackets and hang the hood using its 2 recessed FRONT

HOLES (C and D). While holding the hood, attach the power cable to the hood using the

strain relief.

VERTICAL EXHAUST INSTALLATION AND NON-DUCTED INSTALLATION ONLY

5 ] Hang the hood on the brackets using the 2 recessed FRONT HOLES (C and D). While

holding the hood, run the house power cable into the hood through the strain relief

previously installed in step 6 on page 10. Attach power cable to the hood.

6 ] Connect the ductwork to the hood and use metal foil duct tape to make joints secure and

air-tight. Make sure the damper assembly (or round duct plate) enters the ductwork and

that the damper opens and closes freely.

NOTE: See final installation steps on next page.

Install the Hood (EZ1 brackets)

DUCTED INSTALLATION ONLY