Dali PHANTOM E Serie Manuel page 10

The other switch can increase the midrange level by 3 dB when switched from the
"Normal" setting to the "Mid+" setting. The K-60 LP features the High+ switch only.
4.4 Speaker Rotation – Using the Compass
When the grille is removed you can see a compass ring round the edge of the
loudspeaker bezel, which can be used to read out the rotation of the loudspeaker
relatively to, for example, a fixed line on the ceiling. The tweeter is slightly off-center
and should be positioned so it is closest to the main listening position (see figure 7).
The PHANTOM E-60 S incorporates a compass ring around the edge of its bezel
(see figure 7B), that can be used to read out the rotation of the loudspeaker relative
to, for example, a fixed line on the ceiling. The tweeters should be positioned so they
are closest to the main listening position.
4.5 Connection of Cables/Selection of Cables
Your choice of cables is a crucial element in your installation. Be aware that replacing
cables after installation is a difficult task. Therefore, select quality cables from the
beginning. Please consult your authorized DALI dealer for further advice on which
cable to select.
When connecting the cable to the loudspeaker and the amplifier, it is important that
the loudspeaker is connected in correct phase. The red (+) loudspeaker terminal
must be connected to the red (+) amplifier terminal. The black (-) loudspeaker
terminal must be connected to the black (-) amplifier terminal. If the loudspeakers
are not connected in correct phase, the soundstage will typically be diffuse and the
bass will be weak.
Additionally for the E-60 S, the stereo (left and right) cables require connection
to the correct terminals. Connect the left channel cable to the terminals on the
side marked "L" on the product label, and connect the right channel cable to the
terminals on the side marked "R".
To insert the cable end into the spring loaded terminals of the speaker, remove
cable insulation so that approximately. ½" / 12 mm of bare wire is exposed. Press
the top of the terminal down and insert the bare wire into the opening. When the
wire is fully in place with no loose strands exposed, release the terminal. The cable
is now connected. Please refer to figure 8 for correct cable connection.
5 . 0 C U T - O U T T E M P L AT E
The enclosed cut-out template (see figure 9) can be used to initially visualize how
your speakers should be mounted and for marking where the cut-out should be
made. Tape the template at the preferred mounting position, so that you can mark
the necessary opening. The minimum mounting depth for the DALI PHANTOM
E-50, E-60 and E-60 S is 95 mm / 3.7", for the DALI PHANTOM K-60 it is 100 mm /
3.9", for the DALI PHANTOM E-80 it is 106 mm / 4.2", and for the DALI PHANTOM
K-80 it is 113 mm /4.3". The minimum mounting depth for the DALI PHANTOM K-60
LP is 38 mm / 1.5".
10