Cooper Lighting Solutions Halo HCM Serie Instructions D'installation page 8

Installation Instructions – HCM Series Multi Head Installation
2a. Refer to figures 1.9, 1.10, 1.11, 1.12 respectively for
applicable ceiling cut-out dimensions for the multi-head
being installed.
2b. Draw Input wires from sheet rock ceiling cut-out.
(Figure 2.2)
Access Plate
Figure 2.2.
i. Draw Input wires (Black & White) from flexible
conduit through access plate.
ii. Connect Black to Black and White to White wires by
using wire nuts provided. (Figure 2.3)
iii. Connect Ground wire to driver back plate using
#8-32 screws (Figure 2.3)
Flexible Conduit
Ground wire
#8-32 Screw
Black Wire
Wire Nuts
Figure 2.3.
8
Cooper Lighting Solutions
Sheet Rock/
Ceiling
Flexible Conduit
#8-32 Screw
Access Plate
Sheet Rock/
Ceiling
White Wire
IB517062ML Installation instructions
iv. Assemble access plate with #8-32 screws back to
housing by tucking wires inside, Connect flexible
conduit to access plate. (Figure 2.4)
Sheet Rock/ Ceiling
Figure 2.4.
3. Feed safety straps into safety bracket by knotting. Make
sure straps are pulled tightly against the ceiling. Raise
the fixture housing onto ceiling/ Sheet rock. (Figure 2.5)
Sheet Rock/ Ceiling
Safety Brackets
Figure 2.5.
Flexible Conduit
Safety Straps
Fixture