Cooper Lighting Solutions Fail-Safe MWL Instructions D'installation

IB519122EN
Installation Instructions – MWL
Instructions d'installation – MWL
Instrucciones de instalación – MWL
Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this product
must be performed by a qualified electrician. This product must be installed in accordance with the
applicable installation code by a person familiar with the construction and operation of the product and
hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting any
maintenance. Disconnect power at fuse or circuit breaker.
Risk of Fire- Minimum 90°C supply conductors.
Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.
Risk of Personal Injury- Due to sharp edges, handle with care.
Must be very careful if power tools are used to install the fixture. Uncontrolled torque setting may lead to
thread/gasket damage or lens breakage.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.
DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind that may
arise from the improper, careless, or negligent installation, handling or use of this product.
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
NOTICE: These instructions do not claim to cover all details or variations in the equipment, procedure, or process
described, or to provide directions for meeting every possible contingency during installation, operation or maintenance.
When additional information is desired to satisfy a problem not covered sufficiently for user's purpose, please contact your
nearest representative.
NOTICE: Proper grounding is required to insure personal safety. Carefully observe grounding procedure under installation
section.
NOTICE: Fixture may become damaged and/or unstable if not installed properly.
Note: Specifications and dimensions subject to change without notice.
GENERAL: Upon receipt of fixture thoroughly inspect for any freight damage, which should be brought to the attention
of the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label on the housing to
assure you have received the correct merchandise.
NOTICE: Fluorescent lamps contain Mercury. Dispose according to local, state, or federal laws.
CLEANING: The reflector and lens may be cleaned with any non-abrasive cloth and mild detergent (i.e. 409 Cleaner). Cleaning
should be done on the lens at room temperature, and out of direct sunlight. To remove paint, lipstick, marker, etc., the
following solvents may be used:
RECOMMENDED:
a) A solution of three (3) parts alcohol, one (1) part TOLUOL.
OR
b) Four (4) parts alcohol, one (1) part Methylethylketone MEK). Also safe, but less effective: Naphtha, Butyl
Celiosolve, Kerosene.
WARNING
Fail-Safe