Lamborghini Caloreclima CRONO REM Manuel De L'utilisateur page 83

2. The value sent is outside the range for this parameter→ the displayed value is limited by the maximum (or
minimum) value.
3. The value sent is outside the range for this parameter → the displayed value remains the same displayed before
the change (the value is rejected).
4. Permanent display of the symbol "- -": the boiler card does not respond to the Comando Remoto or the
response of the boiler card is INVALID data.
11. TIMED FUNCTIONs
The timed function implemented by the Comando Remoto allows the management of a temperature setting for a
specific time interval, after which it returns to the standard management.
The function can be activated when the active operation status is INV.
This function cannot be activated if the ambient probe is not enabled (AMBON = 0).
11.1 Vacation
To activate the function, press the button
indication of function timing (for example: MM60 means 60 minutes), whereas the lower digits show the setpoint
temperature during the function.
To modify the duration of the function, press the buttons
maximum duration is 45 days.
Once the duration has been set, press the button
The countdown begins in the upper digits and indicates the time remaining until the end of the function.
on the display.
After starting, the function can be stopped with the buttons
for more than 3 seconds. The upper digits display (blinking) the
and
to confirm.
or
cod. 3542A990 - Rev 01 - 03/2022
. The minimum duration is 10 minutes, the
.
blinks
83
EN