Lamborghini Caloreclima CRONO REM Manuel De L'utilisateur page 70

5. BasIC DIsPLay
When the modulating Comando Remoto is switched on, after the start-up procedure, the basic display page is
activated. The upper digits show the current time, the lower digits show the ambient temperature detected by the
temperature sensor integrated into the Comando Remoto, if AMBON = 1 [or the boiler flow setpoint (CH SL) if
AMBON = 0 and CL EN = 0 (see installer menu description)].
The other active icons depend on the operation status and on the ambient temperature management mode, as
described in the following paragraphs.
6. OPERaTION sTaTUs
From the basic display, use the button
The possible states are as follows.
Mode Icons Description
OFF Heating is disabled, whereas the instant DHW request remains enabled.
The frost protection function remains active, if enabled.
INV Winter mode: heat generation requests are active for both the heating circuit and DHW.
EST Summer mode: only the DHW circuit is active. Heating requests are inhibited.
70
EN
to change the operation status of the remote control.
cod. 3542A990 - Rev 01 - 03/2022