Grundig M 2050 BT Mode D'emploi page 29

SETTINGS
­ - --------------------------------------------------------------------------------------------------------------------------------------
Tuning­and­storing­FM­radio­sta-
tions
After connecting the hi-fi system to the mains
power for the first time, you can start the auto-
matic station search.
1 Switch on the hi-fi system by pressing »
«­on the device or »
the remote control.
Note:
If you switch on the hi-fi system with »
7
» « on the device, select with »
FM input source.
2
Activate the automatic station search by press-
ing » «.
– Display: »AUTO SYNC« for a short time.
– The device searches for up to 40 stations
with strong reception and stores them auto-
matically. After the search has finished, you
will hear the station stored at preset 01.
Notes:
You can cancel the automatic station search
7
by pressing » «.
7
You can restart the automatic station search
7
by pressing »PROG« until the frequency
display changes to rapid run-through.
Setting­and­storing­radio­stations­
manually
1 Set the radio station by briefly pressing »
or » « repeatedly.
4
– Display: the frequency changes in steps of
50 kHz;
or
press and hold down »
frequency changes to rapid run-through.
2
Save a radio station as a preset by pressing
»PROG«, selecting the preset with »
» « and then press »PROG« to save.
3 To search and save more radio stations, repeat
steps 1 to 2.
All manuals and user guides at all-guides.com
8 « or »
8 « or »FM/DAB« on
8
« the
3
« or » « until the
3 4
Setting­the­time
The time is updated automatically if a DAB or
RDS radio station transmits a time signal.
Note:­
The time must be reset after a power failure
7
or after disconnecting from the mains.
1­Select the DAB input source by pressing
»SOURCE« on the device or »FM/DAB« on
the remote control.
« or
2
Select a DAB radio station by pressing »
or » « on the device »
remote control.
3 Press »INFO« on the remote control to switch
to the time display for the DAB radio station
and confirm the time with »
– Display: » CT SYNC «, the time is adopted.
Notes:
Some RDS stations transmit an RDS time
7
signal. If the selected RDS station transmits
time information, the time can be updated
automatically.
Press »INFO« repeatedly until the time is
displayed. If »RDS CLK« displayed, the time
signal has not yet been received. Please
wait until the time is displayed.
If the correct time is displayed, press and
hold » « to confirm it.
«
The time must be reset after a power failure
7
or after disconnecting from the mains.
« or
«
« or » « on the
e II«.
29­
ENGLISH