Fox F28-186A Traduction D'original page 37

IV. Speed adjustment FIG.10
By moving the belt on the engine and flywheel pulleys you can use the bandsaw at two different speeds.
Inside the lower door there are some instructions explaining how to place the belt to obtain two different speeds.
1. Open the lower door with a screwdriver.
2. Loosen the screws motor indicated
3. Loosen the belt by turning the motor unclockwise.
Move the belt on the desired position, tighten the belt again and close the lower door by using a
screwdriver.
- SMALL ENGINE PULLEY – LARGE FLYWHEEL PULLEY: blade speed 660 m/min, suitable for hard
wood types, plastics.
- LARGE ENGINE PULLEY – SMALL FLYWHEEL PULLEY: blade speed 960 m/min for all soft wood
types.
Caution!
Do not place the belt obliquely, since it would suffer damages.
V. Adjustment of workbench's inclination FIG.2
The workbench can be moved from 0 and 45°. To move it, loosen the lock screw (37), move the workbench to the
desired angle and tighten the screw (37).
VI. Rip fence FIG.4
The rip fence (33) can be assembled both on the left and on the right of the saw blade. Choose the position by
using a graduated scale, place the guide and lock it by lowering the front lever A.
All manuals and user guides at all-guides.com
EN
31