Makita UV3200 Manuel D'instructions Original page 14

TROUBLESHOOTING
WARNING: Before solving troubles, switch off the machine, pull out
the mains plug, and wait until the machine stops completely.
Trouble
The machine does not start.
There are cracking sounds
from the machine.
There are strange noise
from the machine.
The machine does not reach
its maximum power.
Poor result.
OPTIONAL ACCESSORY
CAUTION:
• These accessories or attachments are recommended for use with
your Makita tool specified in this manual. The use of any other
accessories or attachments might present a risk of injury to persons.
Only use the accessories or attachments for their stated purposes.
• If you need any assistance for more details regarding these
accessories, ask your local Makita Service Center.
There are several types of cutting tool:
• Scarifying blade - The sharp edge of a blade scarifies the ground and cuts roots.
• Raking blade (optional accessory) - Removing the lawn and leaves by fine needles.
NOTICE:
• Some items in the list may be included in the tool package as standard accessories. They may differ from country
to country.
14
Possible cause
Power supply is not plugged in.
Defect of power cord.
Defect of electrical circuit.
Lock-off button is not pressed.
Foreign matter is entangled in the
cutting tool.
Defect of drive belt
Power source has low voltage than it
required.
Air vents are clogged.
Grass is too high.
Cutting tool is worn out or damaged.
Scarified surface exceeds the machine
capacity.
Scarified depth is not correct.
Remedy
Connect the power supply.
Unplug immediately. Ask your local Makita authorized
service center to repair it.
Ask your local Makita authorized service center to repair
it.
Press the lock-off button and pull the start/stop lever.
Switch off the motor, unplug, and wait until the cutter tool
stops. And then remove the foreign matter.
Ask your local Makita authorized service center to repair
it.
Try another power source. Check whether appropriate
power source is deployed.
Clean the air vents.
Mow the grass before scarifying.
Replace it.
Only scarify a surface which is in accordance with
machine capacity.
Adjust the depth of the cutting tool.