VALPES ER10 Documentation Technique page 8

Electric connection
RESPECT SAFETY INSTRUCTIONS
Our cable glands are designed for cables with a diameter between 7mm and 12mm. The used cables must be able to
withstand the ambient conditions (maximum temperature 55°C).
•
Remove the position indicator, unscrew the four screws and take off the cover.
SUPPLY AND CONTROL WIRING
•
Ensure that the voltage indicated on the actuator ID label corresponds to the voltage supply.
•
Connect the wires to the connector (appendix p.14-15 mark 8) in accordance with the required control mode.
3-points modulating mode
N
-
Ouvrir
Open
Auf
T/E
1 2
3
WIRING OF THE FEEDBACK SIGNAL
Our actuators are equipped with two simple limit switch contacts normally set in their
open position (NO). As per factory setting, the white cam is used to detect the open
position (FC1) and the black cam is used to detect the closed position (FC2).
This feedback system accepts voltages between 24V and 240V AC/DC.
•
Unscrew the right cable gland and insert the cable.
•
Remove 25mm of the cable sheath and strip each wire by 8mm.
•
Connect the wires to the terminal strip (appendix p.14-15 mark 4) in accordance with
the diagram beside.
•
Tighten the cable gland.
SETTING OF END LIMIT SWITCHES
The actuator is pre-set in our factory. Do not touch the two lower cams in order to avoid any malfunctioning or even damage to
the actuator.
•
To adjust the position of the auxiliary contacts, make rotate the two superior cams by using the appropriate wrench.
CLE DE REGLAGE
SETTING KEY
SCHLÜSSEL
•
Re-mount the cover, fasten the four screws and attach the position indicator.
DSBA2900 rév.16-06-06
On-Off mode, pre-set to closed
Ph
+
Fermer
Close
Zu
N Ph
- +
Ouvrir
Open
Auf
T/E
1 2
3
4-6 5
FC2
FC1
CLE DE REGLAGE
SETTING KEY
SCHLÜSSEL
GB
7
8/19