Shindaiwa EB8520RT Manuel D'utilisation page 6

Assembly
Prior to Assembly
Before assembling the blower, make sure
you have all required components.
■
Power unit and blower assembly.
■
Flexible tube, swivel tube, two nozzles
and straight tube.
■
Throttle assembly.
■
Two tube clamps (102 and 89mm).
Assembling the Blower
IMPORTANT!
This unit is equipped with a static dis-
charge reduction wire. This wire helps
direct static buildup into the air stream
reducing the felt amount to the operator.
1. Place the blower upright on the ground
or a sturdy work surface and note parts
orientation as shown in Figure 4.
2. Remove static wire from package and
fix eyelet to right hand engine cover
screw. See Figure 5.
3. Turn the discharge tube out to a right
angle and slip anti-static wire through
the 102mm clamp and flexible tube.
4. Install throttle cable holder just forward
of the 102 mm clamp, pinching loops
together to fit over end of flexible tube.
See Figures 6A and 6B.
5. Slip the flexible tube over the end of the
90° discharge tube, and secure with the
102 mm clamp.
6. Slide the throttle assembly over the swivel
tube. Do not tighten clamp at this time.
NOTE:
Check to make sure that the 90° dis-
charge tube swivels freely. If any binding
is present, loosen 102 mm clamp and
pull wire towards engine to get more
slack and recheck for free movement.
6
All manuals and user guides at all-guides.com
■
This Owner's/Operator's Manual
and a tool kit containing a tool
bag, 4 mm hex wrench, 5 mm hex
wrench and a combination spark plug
wrench/screwdriver.
■
Lead wire assembly (anti-static).
Carefully inspect all components for
damage.
Anti-Static
Wire
102mm
Clamp
Figure 4
The terms "left", "left-hand", "LH"; "right",
"right-hand", and "RH"; "front" and "rear"
refer to directions as viewed by the opera-
tor during normal operation.
Flexible Tube
Throttle Cable
Holder
90° Discharge
Tube
Straight Tube
Swivel Tube
89mm Clamp
IMPORTANT!
Throttle
Assembly
Swivel
Tube
Long Nozzle (ø74 mm)
Short Nozzle
(ø65 mm)