Shindaiwa EB8520RT Manuel D'utilisation page 11

Throttle Control
The blower is equipped with a multi- function
throttle control. The "Cruise" function allows
the operator to use a thumb controlled lever
for constant speed use without using the
throttle trigger. This is useful for limiting the
fatigue caused from holding the throttle for
extended periods of time.
Cruise Function
Using the right thumb, push the throttle lock
lever down until the desired min
reached. See Figure 14.
Throttle Limiter
The blower has a throttle limiter function
that allows the operator to pre-set the
maximum engine speed. This is useful for
reducing the noise emitted by the blower
in noise sensitive areas.
Setting Throttle Limiter:
For reduced noise setting, move the
throttle limiter located on the right side of
the throttle control to the dB setting. See
Figure 15.
Adjusting Throttle Limiter:
1. Remove the plug located at the top of
the throttle assembly. See Figure 16
2. Move the throttle limiter lever to the
"dB" setting. See Figure 16.
3. With the engine running and while
depressing the throttle trigger, use a
small Phillips screw driver to turn the
adjustment screw clockwise to decrease
min and counter-clockwise to increase
-1
until desired limited min
-1
4. Reinstall limiter adjustment plug.
All manuals and user guides at all-guides.com
On the opposite side, a two position "Lim-
iter" control allows full engine speed when
set for "Turbo" or limits the throttle to a
pre-set engine speed when set to low noise
(dB) setting.
setting is
-1
Thumb
Control Lever
Figure 14
Turbo Setting
dB Setting
Figure 15
Remove limiter
adjustment plug
Figure 16
is achieved.
Throttle Limiter Adjustment
Throttle Limiter
Lever
RT Throttle RT
To bring min down to idle, push lever
-1
back up into original position.
NOTE:
With the throttle limiter adjusted to 3,850
min , the blower will have a sound level
-1
of 65 dB(A) measured at 15m (50 feet).
11